Our Service
The plasma cutter allows to implement the cutting operation quickly and with minimal errors. Finished products come out without sagging, roughness and fire scales.
You are able to cut almost any type
of metal with plasma cutter.
The raw materials in different
states are able to be
used for the cutting-out.
it is not required to clean the raw material from paint or rust.
The plasma cutter allows to get very smooth
and accurate small- size cutting without the waste.
Despite the variety of conditions, steel still remains the most reliable and practical material for the manufacture of metal containers. Rolled plates made of different brands of steel are used with this purpose.
You are able to buy from our company the containers of any size, shape and any destination.
Almost all the types of metal processing are concentrated in our enterprise.
Therefore, there are no restrictions on technologies for us.
Screw cutting is one of the work types that can be done by means of the turning machine. The screw thread is used in different fields, including mechanical engineering, as well repair and construction works.
Thanks to turning processing, the products will be of high quality and accuracy.
Metal turning machine is able to turn both simple (screw bolt, nut, sheave) and more complex products (shaft, coupling, flange, spindle).
The pieces made using the metal turning machine will be much more accurate: the measurement can be not in the millimetres, but in tenths, even hundredths of a millimetre.
Two intercomplementary operations, i.e., abrasive blasting and painting, are integral stages of the procedure for cleaning of different types of surfaces from old enamel, dirt, mud, rust and further painting.
The surfaces are cleaned by means of sand blasters and shot blasting chambers.
The materials used for the cleaning are different types of the abrasives, e.g., shot and sand.
The painting is implemented after the cleaning.
We implement the construction of modern buildings of any type (industrial, agricultural buildings, warehouses and hangars, administrative, sports, trade buildings).
Construction stages
1. Choosing optimal constructive solution,
2. Free of charge calculation of the construction cost,
3. Drawing up the project documentation on the facility,
4. Manufacturing of metal structures (manufacturing, abrasive blasting
and painting)
Installation works
1. Foundation,
2. Metal structures installation,
3. Wall cladding (sandwich panels, profiled sheet),
4. Roofing,
5. We do not use the subcontracting.
1037
Finished projects
5798
Engineer
747+
Workplaces
Tell us about your project.